|
The M9000 offers several important benefits including:
• High speed consistent cutting, repeatable accuracy &
flexibility
• Optimum material yield, labour savings & lower
operating costs
• Not limited to one specific material or application
• Built to run non-stop in any type of industrial
environment
• Compatible with most off-the-shelf & industry specific
software
Typically, the M9000 is used for single-ply cutting, but
depending on the material, multiple layers may be cut, especially if a
thin sheet of High Density Polythene Film is utilised on the top of the
lay to seal the vacuum.
The M9000 features three tangentially controlled tool
holders, which are interchangeable & may fit with any combination of
different sized rotary blades, different angles of straight knife
blades, variously shaped notch punches & a wide range of drill
diameters.
There is also a pen for marking & piece identification &
an optional non-contact ink jet printer for faster marking capability.
Standard Equipment:
• Pentium Processor controlled computer
• Motion control board, multifunction board, SVGA colour
monitor, graphics card, keyboard, mouse
• Onboard plotter control panel with alphanumeric user
interface
terminal
• Electronics control cabinet
• Diode laser pointing alignment tool
• Rack & pinion table attachment system
• Festooning system with RF resistant cables & E-chain
support
• Four remote emergency stops: two on carriage, two on
table
• Custom vacuum table
• Laser alignment tool & pneumatic pen holder & marker
• Computer controlled tangential cutting devices
• Porous plastic cutting surface
Supporting Control Software:
• EasiCut Windows based plotter motion control,
calibration &
diagnostic software
• Translate design communications software interface –
converts .GBR, .DXF & numerous other file formats
|
Additional Options:
• Table configuration into several active cutting zones
• Extra cutting blades, changeable punch awl, adjustable
punch head
• Easijet system – various cutting surfaces available
for
different material applications (including Lexan,
Urethane,
PVG, etc.)
Material Handling Options:
• Motorised power cradle with edge control (300 lb or
500 lb capacity)
• Manual cradle (300 lb capacity) with bearings
• EasiPull material handling system (includes gripper,
end cutter with clamp, interface software)
• Heavy duty Expandabar (300 lb or 500 lb capacity)
• Roll stand (upright assembly) with edge control
• A-Frame 8-roll fabric rack
Software Options:
• Supply & support of off-the-shelf &
industry specific software packages
Specifications:
Maximum Cutting Speed:
60" (1.52m) per second
Maximum Plotting Speed: 60" (1.52m) per
second
Acceleration:
1.3G's
Standard Table Lengths: 12' (3.66m):
24' (7.32m)
36' (10.97m): 48' (14.63m): etc.
Additional 4' (1.22m) sections available
Standard Table Widths: 72"
(1.83m): 78" (1.98m)
84" (2.13m): 90" (2.29m): etc.
Available in any 6" increment
Drive Power: Dual X, Y & Theta axis “Brushless” servo
motors Includes industrial amplifiers & closed-loop encoders
Drive System:90° gear reduction drive
Electrical Requirement: 120v @ 30 amps per phase
Compressed Air Requirement: 120 psi @ 0.5 cfm
Installation & Support
• Complete system installation, including integration &
on-site training
• One follow up visit lasting two days
Warranty: One year on non-consumable
parts & labour
|
